Kendrion Worldwide

Division Automotive

Kendrion N.V.

Kendrion N.V. is a public limited liability company incorporated under the laws of the Netherlands, with its registered office in Zeist.

For general requests:

> Contact
Kendrion Group Services
Mono- / Bistable Single Stroke Solenoids from KENDRION

Locking Solenoids

Locking-Line

Single-stroke solenoids of the Kendrion Locking Line are locking units especially for use in safety devices. Special emphasis has been put on compact design, universal mounting options and integrated feedback.

Specifications & Technical Details

Specification from - to
Supply voltage [V] 24 V DC / 230 V AC A female connector with integrated bridge rectifier allows for use with alternating current.
Duty cycle [%] 100
Stroke [mm] 8 - 15
Force [N] 5 - 50 The magnetic forces indicated are reached at 90% of the nominal voltage and in warmed-up condition.
Radial forces [N] 1000 - 3000
Protection class device (IP) IP40 / IP64
Protection class connection (IP) IP40 / IP64
Accessories Female connector with / without integrated bridge rectifier
Connector plug
Locking pin housing
Installation type By threaded holes at front and bottom side
Thermal class F
Comment Locking pin Ø: 10 - 16 mm
   

Product Information

The electromagnetic locking unit was especially designed for the use in protective devices of all kinds of machines and automation plants. Special emphasis has been put on compact design, universal mounting options and integrated feedback of the locking function.

Depending on the requirement two types of solenoids are available.

1. Devices unlocked without voltage in which the reset of the locking pin is achieved by a spring.

2. Devices locked without voltage in which the reset of the locking pin is achieved by electromagnetic force.

Solenoid armatures and locking pins are led separately in maintenance-free bearings. The locking bolt is manufactured out of non-corrosive and non-magnetic stainless steel.

The micro-switch directly integrated into the pin housing signals the respective position of the locking pin at appr. 0.5 mm to 1 mm after leaving the the stroke starting position resp. before reaching the stroke end position.

Basically the stroke movement takes place from the stroke starting position to the stroke end position (active direction of movement), while the armature reset is accomplished by an integrated spring force (passive direction of movement).

All products are manufactured and tested according to DIN VDE 0580/07.2000.

Design subject to change.

Related Magnets